The Statbook FAQ - General Usage

Advanced search

I used to indicate .1 for a 1/3 inning in the older software. I am getting some weird numbers if I use .3 or .7. How can I go back to using .1 and .2 for 1/3, and 2/3 innings?

As long as you have Statbook version 3.2 (or higher), this is now possible. Be sure to check out the Videos Page for a short tutorial on how to do this. The basic steps are as follows:

Go to the Games Input and change all your partial innings to .1 or .2
For every report and every statistic which uses Innings Pitched (i.e. IP, ERA, WHIP) you will need to select that field and use the corresponding "Favorites" formula

You cannot comment on this entry

~ 0 min
ID #0
Statbook
2009-11-24 19:06
PDF version

Related entries

The only choices for innings are 6 or 9. I've changed the ERA to reflect calculations for 7 innings, but I need to add an inning for the "position by inning". How do I do that?
The only choices for innings are 6 or 9. I've changed the ERA to reflect calculations for 7 innings, but I need to add an inning for the "position by inning". How do I do that?
You calculate ERAs for 6 or 9 innings. My ERA is based on 7 innings (or another number). How do I change this?
I made a set for positions (by inning) and batting order under the "Games" section for my first game. Is there a way to copy that game roster to my next game?
I am using the tertiary point (dot notation) for Innings Pitched (i.e. .1, .2) but I am seeing, under totals in some reports, with .3( e.g. 11.3), which is not correct and should be 12. How do I fix this?